Drywall Repair: Some Common Drywall Problems And Their Easy Solution

Drywall, like any other parts of your house, will have some problems over time. But there is no need to worry, these problems are usually fixable with some simple steps. If you are into DIY, then you can do the work yourself or you can hire services for drywall repair in Parker CO to do the job for you.
To help you out, here are some common drywall problems that people face and their solution.

Screws are driven a bit too far

When the screws are driven too far they break the paper face surface of the wallboard and when the wallboard is broken the nail or screw loses its holding capacity.
Solution: Use special drill attachments that let you regulate the depth of the screw. Give the screw a half-turn or a quarter-turn so that it remains just below the surface of the paper.

Too tight drywall joints

Tightening the drywall joints too much can lead to the drywall sheets to break. When two drywall sheets are aligned side by side, tightening the screws too much causes the sheets to break due to lack of spaces for contraction and expansion.
Solution: To prevent this problem, allow some space between the sheets. The ideal gap between the sheets is ⅛ inch.

Drywall is over sanded

Sometimes DIYers over sand the drywall in an attempt to get a smooth surface. Sanding is necessary to get rid of the bumps in the drywall, but when you sand vigorously over the mud compounds and joints, there is always a risk of sanding into the fiberglass tape or the paper that covers the seams of the drywall. This will damage the integrity of the drywall.
Solution: The solution is pretty simple. Install low lighting at an angle to the wall that that will highlight the bumps and rises.

Improper alignment of holes for electric boxes

If you are a DIYer then it is quite difficult for you to cut holes in the drywall sheet that align perfectly with an electrical receptacle. It is a good idea to take the help of expert services for drywall repair in Parker CO to do this task but if you still want to do it yourself, there is a way to do it correctly.
Solution: Before you install the receptacle, mark the area with a painter’s tape. Now install the drywall and once the drywall is completely installed then only cut a hole in the drywall.

Drywall dents

This is another common drywall problem. Dents can occur in the drywall due to many reasons, it could be due to furniture or water damage. This is a very easy solution to fix.
Solution: Take some drywall compound and with a taping knife apply it directly over the damaged area. Let it dry for 24 hours and then you can sand the drywall and apply paint over it.

Not checking the fit before fastening the screws

This is another common mistake that DIYers tend to make when installing or repairing drywall. Even if you have the perfect cutout for the electrical box it is essential that you check the fit. If the fit isn’t right it can create cracks in the drywall or cause unnecessary tension in the surface of the wall.
Solution: Before fastening the screws measure the electrical boxes so that they fit perfectly in the cutout when you press and fasten them in the position.

The inside corners are ragged

A common problem that occurs when taping the drywall is that the inside looks a bit ragged. Achieving the perfect finish can be pretty tough and using the right measures can fix the issue easily.
Solution: When taping the drywall use metal-reinforced tapes. These tapes come with a metal angle with the paper flange that gives perfectly smooth interior corners. The metal tape also gives the taping knife a rigid surface to slide along when taping the drywall.